McIntosh mc402 Endstufe
McIntosh mc402 Endstufe
Posted On 11.08.2022
Last Update On
11.08.2022
Description
Original Description is in
German, other language texts are translations and can contain errors.
EnglishDeutschTurkish
Rarely offered McIntosh powerhouse in top condition. The McIntosh MC402 power amplifier comes from a good family and was only used sporadically on Sonus Faber loudspeakers.
The original operating instructions and certificate are included in the scope of delivery.
Additional information:
Specs
Specs
Power Out Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
400 watts into 2 ohm load
400 watts into 4 ohm load
400 watts into 8 ohm load
Power Output Mono Parallel
Minimum sine wave continuous average power output is:
800 watts into 1 ohm load
800 watts into 2 ohm load
800 watts into 4 ohm load
Output Load Impedance
2, 4 or 8 ohms (stereo mode)
1, 2 or 4 ohms (mono mode)
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is
0.005%
intermodulation distortion
Maximum Intermodulation Distortion if instantaneous peak output per channel does not exceed
twice the rated output, for any combination of frequencies from 20Hz to 20,000Hz, with all channels
operating is 0.005%
Dynamic headroom
2.1dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
sensitivity
2.0 volts unbalanced input
4.0 volts balanced input
A weighted signal to noise ratio
94dB Unbalanced (120dB below rated output)
98dB Balanced (124dB below rated output)
input impedance
10,000 ohms unbalanced inputs
20,000 ohms balanced inputs
Wide band damping factor
Greater than 40
power requirements
100 volts, 50/60Hz at 12 amps
110 volts, 50/60Hz at 11 amps
120 volts, 50/60Hz at 10 amps
220 volts, 50/60Hz at 5 amps
230 volts, 50/60Hz at 5 amps
240 volts, 50/60Hz at 5 amps
Note: Refer to the rear panel of the MC402 for the correct
voltage.
Overall Dimensions
17-1/2 inches (44.45cm) W, 9-7/16 inches (23.97cm) H, 20
inches (50.8cm) D, including clearance for connectors
weight
110.5 pounds (50.1kg) net, 143.5 pounds (65.1kg) in shipping carton
Selten angebotener McIntosh Kraftprotz in top Erhaltungszustand. Die McIntosh MC402 Endstufe kommt aus gutem Hause und wurde nur sporadisch an Sonus Faber Lautsprechern genutzt.
Original Bedienungsanleitung und Zertifikat gehören zum Lieferumfang.
Weiterführende Informationen:
Specifications
Specifications
Power Output Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
400 watts into 2 ohm load
400 watts into 4 ohm load
400 watts into 8 ohm load
Power Output Mono Parallel
Minimum sine wave continuous average power output is:
800 watts into 1 ohm load
800 watts into 2 ohm load
800 watts into 4 ohm load
Output Load Inpedance
2, 4 or 8 ohms (Stereo Mode)
1, 2 or 4 ohms (Mono Mode)
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is
0.005%
Intermodulation Distortion
Maximum Intermodulation Distortion if instantaneous peak output per channel does not exceed
twice the rated output, for any combination of frequencies from 20Hz to 20,000Hz, with all channels
operating is 0.005%
Dynamic Headroom
2.1dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
2.0 Volts Unbalanced Input
4.0 Volts Balanced Input
A-Weighted Signal To Noise Ratio
94dB Unbalanced (120dB below rated output)
98dB Balanced (124dB below rated output)
Input Impedance
10,000 ohms Unbalanced Inputs
20,000 ohms Balanced Inputs
Wide Band Damping Factor
Greater than 40
Power Requirements
100 Volts, 50/60Hz at 12 amps
110 Volts, 50/60Hz at 11 amps
120 Volts, 50/60Hz at 10 amps
220 Volts, 50/60Hz at 5 amps
230 Volts, 50/60Hz at 5 amps
240 Volts, 50/60Hz at 5 amps
Note: Refer to the rear panel of the MC402 for the correct
voltage.
Overall Dimensions
17-1/2 inches (44.45cm) W, 9-7/16 inches (23.97cm) H, 20
inches (50.8cm) D, including clearance for connectors
Weight
110.5 pounds (50.1kg) net, 143.5 pounds (65.1kg) in shipping carton
Nadiren en iyi durumda McIntosh güç merkezi sundu. McIntosh MC402 güç amplifikatörü iyi bir aileden gelir ve yalnızca Sonus Faber hoparlörlerde ara sıra kullanıldı.
Orijinal kullanım kılavuzu ve sertifika teslimat kapsamına dahildir.
Ek Bilgiler:
Özellikler
Özellikler
Güç Çıkışı Stereo
Minimum sinüs dalgası sürekli ortalama güç çıkışı
kanal, çalışan tüm kanallar:
2 ohm yüke 400 watt
4 ohm yüke 400 watt
8 ohm yüke 400 watt
Güç Çıkışı Mono Paralel
Minimum sinüs dalgası sürekli ortalama güç çıkışı:
1 ohm yüke 800 watt
2 ohm yüke 800 watt
4 ohm yüke 800 watt
Çıkış Yük Empedansı
2, 4 veya 8 ohm (stereo modu)
1, 2 veya 4 ohm (mono mod)
Anma Güç Bandı
20Hz - 20.000Hz
toplam harmonik bozulma
Herhangi bir güçte Maksimum Toplam Harmonik Bozulma
250 miliwatt'tan nominal güç çıkışına kadar olan seviye
%0,005
intermodülasyon bozulması
Kanal başına anlık tepe çıkışı aşmazsa Maksimum İntermodülasyon Bozulması
tüm kanallarla 20Hz ila 20.000Hz arasındaki herhangi bir frekans kombinasyonu için nominal çıkışın iki katı
işletim %0,005
Dinamik boşluk payı
2.1dB
Frekans tepkisi
+0, -0.25dB 20Hz'den 20.000Hz'e
+0, -3dB 10Hz'den 100.000Hz'e
duyarlılık
2.0 volt dengesiz giriş
4.0 volt dengeli giriş
Ağırlıklı bir sinyal-gürültü oranı
94dB Dengesiz (nominal çıkışın 120dB altında)
98dB Dengeli (nominal çıkışın 124dB altında)
giriş empedansı
10.000 ohm dengesiz girişler
20.000 ohm dengeli girişler
Geniş bant sönümleme faktörü
40'tan büyük
Güç Gereksinimleri
12 amperde 100 volt, 50/60Hz
110 volt, 50/60Hz, 11 amper
120 volt, 50/60Hz, 10 amper
220 volt, 50/60Hz, 5 amper
5 amperde 230 volt, 50/60Hz
240 volt, 5 amperde 50/60Hz
Not: Doğru bilgi için MC402'nin arka paneline bakın.
Gerilim.
Genel boyutları
17-1 / 2 inç (44,45 cm) G, 9-7/16 inç (23,97 cm) Y, 20
inç (50,8 cm) D, konektörler için boşluk dahil
ağırlık
110,5 pound (50.1 kg) net, nakliye kartonunda 143,5 pound (65.1 kg)